Use process IDs for optimal settings

To automatically get recommended settings, select the process ID for the process that aligns with your cutting application.

When you select a process ID from the Computer Numerical Control (CNC) or from the XPR® web interface, you automatically get the optimized settings that Hypertherm® recommends for that process.

The preprogrammed settings come from extensive Hypertherm laboratory tests. Because of differences in cutting systems, metals, and consumables, it can be necessary to adjust the settings. However, in most conditions, it is possible to get the best results when you use the default settings that come with a process ID.

  1. Go to the process selection screen on the CNC or to the Operate screen on the XPR web interface.
  2. Select the process ID:
    1. Examine the list of available processes.
    2. Identify the process that best aligns with your cutting application.

      For example, select process ID 1153 to start the settings for 170 A, 12 mm (0.5 inch), mild steel, O2/Air.

    Note:

    Process selection must occur during the Initial Checks state.

  3. If none of the processes are satisfactory:
    1. Select an available process that is almost the same.
    2. Send the necessary offset command or commands to adjust the setting or settings as necessary.

If an unusual cutting process is necessary, speak to your cutting machine supplier or regional Hypertherm Technical Service team.