Register your new Hypertherm system
Warranty information
Recycling information
Contact us
Safety information
Where to Find Information
Install and Set Up the Plasma Power Supply
Operate the Plasma System
Cut and Mark with the Hand Torch
Gouge with the Hand Torch
Troubleshoot Common Problems
- Start here: troubleshooting checklist
  When a problem occurs, go through the troubleshooting checklist first. It is necessary to complete these steps before doing other troubleshooting procedures.
- Frequently used procedures for troubleshooting
- Troubleshooting for common problems
  - The cut quality is unsatisfactory, or the cut does not sever the workpiece
    Unsatisfactory cut quality can have many causes. These can be related to the cartridge, the work lead connection, the gas supply, or an incorrect output current, cut speed, operating mode, or extension cord.
  - The power switch is ON, but the power LED is off
    The power switch is set to ON (I), but the Power ON Light Emitting Diode (LED) is off. The voltage to the control circuits is not sufficient, or a power component has a short circuit.
  - The arc does not transfer to the workpiece
    The plasma arc does not transfer to the workpiece. The continuity between the work lead and the workpiece is unsatisfactory.
  - The plasma arc stopped while cutting, but starts when you fire the torch again
    There is a problem with the Hypertherm® cartridge, the cut height, the air filter element, or the input gas pressure.
  - The plasma arc makes sputtering and hissing sounds
    There is a problem with the air filter element, or it is necessary to clean the input gas supply. There can also be a problem with the Hypertherm® cartridge.
  - The system changes the gas pressure after you set it manually
    The plasma power supply will override manual gas mode under some conditions.
  - The system changes the output current (A) or the operating mode after you set them
  - Possible gouging problems
    When you are gouging with the torch, you may have an issue. Refer to this table to help identify the problem and solution.
  - Troubleshooting for power-related problems with generators
    Problems with input line voltage can occur more frequently with some generators.
- Troubleshooting procedures for fault LEDs and fault codes
Complete Regular Maintenance Tasks

The system changes the output current (A) or the operating mode after you set them

You selected the system setting while the torch was locked

The system does not keep changes to the output current (A) or operating mode while the torch-lock switch is in the yellow lock position or while there is an 0-50-n "Hypertherm® cartridge off" fault condition.

When you set the torch-lock switch to the green "ready to fire" position, the system automatically sets the amperage and operating mode to match the type of Hypertherm cartridge installed on the torch.

Note:

For more information on the 0-50-n fault condition, refer to Troubleshooting for torch-lock switch faults (0-50-n).

Set the torch-lock switch to the green "ready to fire" position before you adjust the amperage or operating mode.