Correct position for the plasma power supply

Make sure that the plasma power supply is in a safe position and location before you operate the cutting system.

Warning
	CHANCE OF ELECTRIC SHOCK Electric shock can cause serious injury. Never cut under water or put the torch in water.

Warning
	TOXIC FUMES CAN CAUSE INJURY OR DEATH Some metals, including stainless steel, can release toxic fumes when cut. Make sure that your work site has sufficient ventilation to make sure that the air quality level complies with all local and national standards and regulations. Refer to the Safety and Compliance Manual (80669C) for more information.

• Do not use the system in rain or snow.
• Put the plasma power supply near the line-disconnect switch or near an approved power receptacle for your installation.

• Keep at least 0.25 m (10 inches) of space around the plasma power supply for sufficient ventilation.

  

• Put the plasma power supply on a stable, level surface before you use it. The plasma power supply can fall over if it is set at an angle greater than 10°.

  

• Do not put the plasma power supply on its side. Doing so can cause a blockage of the air circulation necessary to keep internal components cool.