Register your new Hypertherm system
Warranty information
Recycling information
Contact us
Safety information
Where to Find Information
Install and Set Up the Plasma Power Supply
Operate the Plasma System
Cut and Mark with the Hand Torch
Gouge with the Hand Torch
Troubleshoot Common Problems
- Start here: troubleshooting checklist
  When a problem occurs, go through the troubleshooting checklist first. It is necessary to complete these steps before doing other troubleshooting procedures.
- Frequently used procedures for troubleshooting
  - Restart the plasma power supply
    - Do a cold restart
    - Do a quick restart
  - Troubleshooting for gas pressure problems
  - Keep a clean gas line
    It is extremely important to keep a clean, dry gas line to prevent oil, water, dirt, and other contaminants from causing damage to internal components. A clean gas line also helps you to get optimal cut quality and consumable life.
  - Do a gas test
    Use a gas test to see if sufficient gas pressure is exiting the torch. The gas test lets you see the plasma power supply’s actual gas pressure so that you can compare it to the inlet set pressure.
- Troubleshooting for common problems
- Troubleshooting procedures for fault LEDs and fault codes
Complete Regular Maintenance Tasks

Do a quick restart

Set the power switch on the plasma power supply to OFF (O).
Immediately set the power switch on the plasma power supply to ON (I).

Note:
If a fault occurs while you are using a generator, a quick restart does not always remove the fault. Do a cold restart instead.