Example of external ohmic contact sense

Refer to this example diagram if it is necessary to change the wiring inside of the TorchConnect™ console so that you can use external ohmic contact sense.

1	Torch
2	Ohmic wire, inside of torch and torch lead
3	TorchConnect console
4	Ohmic wire, torch receptacle to ohmic relay
5	Ohmic relay
6	Ohmic wire, ohmic relay to J4
7	Ohmic Printed Circuit Board (PCB)
8	Ohmic wire, J4 to torch lifter or third-party ohmic circuit: pin 1 and pin 2 are connected in the ohmic PCB
9	Torch lifter or third-party ohmic circuit
10	Controller Area Network (CAN) connection
11	Ohmic wire, J4 to torch lifter or third-party ohmic circuit: pin 1 and pin 2 are connected in the ohmic PCB, one ground connection (mandatory)
12	Torch lifter or third-party ohmic circuit