Home
Connect for Communication
Requirements for manual-set mode
This information prepares you to use EtherCAT®, serial RS-422, Ethernet Local Area Network (LAN), or the XPR® web interface through Wi-Fi® or Ethernet LAN to enable or disable manual-set mode

Register your new Hypertherm system
Warranty information
Recycling information
Contact us
Safety information
Electromagnetic Compatibility (EMC)
Specifications
Qualifications and Requirements
Installation
Connect for Communication
- Communication methods for XPR® cutting systems
  There are multiple communication methods to fully operate the plasma cutting system.
- Requirements for EtherCAT®
  This information prepares you to connect the plasma power supply to the Computer Numerical Control (CNC) with EtherCAT® cables.
- Requirements for serial RS-422
  This information prepares you to connect the plasma power supply to the Computer Numerical Control (CNC) with serial RS-422 cables.
- Requirements for discrete
  This information prepares you to connect the plasma power supply to the Computer Numerical Control (CNC) with discrete cables.
- VDC3 PCB installation for AVC with RS-422 and discrete-only connections (if applicable)
  The VDC3 Printed Circuit Board (PCB) installation instructions are for Arc Voltage Control (AVC) with serial RS-422 and discrete-only connections.
- Requirements for the XPR web interface
  You can connect to the XPR® web interface through Wi-Fi® with Access Point (AP) mode or through a direct connection with Ethernet Local Area Network (LAN).
- Requirements for Ethernet LAN (wired)
  Before you use an Ethernet Local Area Network (LAN) interface to connect to the XPR® cutting system, review this information. This information prepares you to use an Ethernet LAN interface.
- Requirements for manual-set mode
  This information prepares you to use EtherCAT®, serial RS-422, Ethernet Local Area Network (LAN), or the XPR® web interface through Wi-Fi® or Ethernet LAN to enable or disable manual-set mode
  - Use wireless or Ethernet LAN to enable or disable manual-set mode
    Do these steps to use the XPR® web interface through Wi-Fi® or Ethernet Local Area Network (LAN) to enable or disable manual-set mode.
  - Use EtherCAT or serial RS-422 to enable or disable manual-set mode
    Do these steps to use EtherCAT® or serial RS-422 to enable or disable manual-set mode.
- Change the device that has control
  Use these steps to make sure that the correct device has control of the plasma power supply.
- Use ohmic contact sense
  You can use internal or external ohmic contact sense. No action is necessary for internal ohmic contact sense. To use external ohmic contact sense, make the following modification to the ohmic wiring inside of the TorchConnect™ console.
- Install a remote on-off switch
  As an alternative to using the main power source, do these steps to install your own remote on-off switch so that you can control power to the gas connect console, TorchConnect™ console, and other parts.
- Install a redundant remote on-off switch
  Do these steps if you want to use the redundant remote on-off switch.
Coolant Installation
Operation
Maintenance
Diagnostics and Troubleshooting
Parts List
Wiring Diagrams

Requirements for manual-set mode

This information prepares you to use EtherCAT®, serial RS-422, Ethernet Local Area Network (LAN), or the XPR® web interface through Wi-Fi® or Ethernet LAN to enable or disable manual-set mode

You must move the remote on-off switch from the ON position, to the OFF position, to the ON position again if manual-set mode is enabled and the remote on-off switch is in the ON position when power is supplied to the cutting system and the 648 Waiting for user input diagnostic code shows on the screen.
Figure 1. Example Information diagnostic code 648
A manual-set mode process will be canceled if you select a new process before the previously selected manual-set mode process starts, if the manual-set mode configuration is not correct, or if there is a firmware update.