Basic mode

When the system is in basic mode, it does not set the operating mode or the output current (A) for you. You must adjust those settings manually.

System behavior also changes in these ways:
  • The system does not record data on pilot arcs or arc transfers for the Hypertherm® cartridge.
  • The fault Light Emitting Diode (LED) on the hand torch flashes yellow for as long as the system is in basic mode.
  • The amperage-adjustment control on the hand torch does not adjust the amperage for as long as the system is in basic mode.

  • You must set the plasma power supply to OFF (O) before you remove the Hypertherm cartridge or move the torch-lock switch to the yellow "lock" position. Otherwise you will get a Hypertherm cartridge missing fault and the torch will not fire.

    To install or change a SYNC® Hypertherm cartridge while in basic mode, or to clear a Hypertherm cartridge missing fault:
    • Set the power switch on the plasma power supply to OFF (O).
    • Install a Hypertherm cartridge.
    • Move the trigger to the green "ready to fire" position.
    • Set the power switch to ON (I).