Install the VDC3 PCB (141511) (if applicable)

Use these steps to install the VDC3 Printed Circuit Board (PCB) in the plasma power supply. A 10 mm hex socket wrench or nut driver and a Phillips® #2 screwdriver are required.

  1. Use a 10 mm hex socket wrench or nut driver to remove the rear panel of the plasma power supply.
    This image shows the rear panel removed from an example plasma power supply.
  2. Use a #2 Phillips screwdriver to remove the four screws from the studs.
    This image shows the location of the four screws on the VDC3 Printed Circuit Board.
  3. With J3 on top, use the four screws to install the PCB on the studs.

    Tighten the screws to 0.9 N∙m (8.0 lbf∙in).

    This image shows the VDC3 Printed Circuit Board installed in the plasma power supply with the four screws.