Configuration requirements for the VWI or OptiMix gas connect consoles
| A | Plasma power supply |
|---|---|
| B | Gas connect console (VWI or OptiMix) |
| C | Torch connect console |
| D | Torch |
| E | Cutting table |
| F | Computer Numerical Control (CNC) |
| 1 | CNC lead |
| 2 | Work cable |
| 3 | Controller Area Network (CAN) cable |
| 4 | Power cable: 120 VAC |
| 5 | Coolant hoses: 1 supply, 1 return |
| 6 | Pilot-arc cable |
| 7 | Negative cable |
| 8 | Pilot-arc, coolant-hose, shield-water assembly |
| 8a | Pilot-arc cable |
| 8b | Coolant hoses: 1 supply, 1 return |
| 8c | Shield-water hose (VWI or OptiMix) |
| 9 | Power cable, CAN, 5-gas hose assembly |
| 9d | Power cable (120 VAC) |
| 9e | CAN cable |
| 9f | 5 gas hoses (VWI or OptiMix) |
| 10 | Torch lead |
| 11 | Regulators – Position a gas regulator within three meters (10 feet) of the gas connect console or adjust inlet gas pressures to tolerances specified in the process gas requirements. |
| 12 | Hoses for supply gases |
| 13 |
Gases and water VWI: O2, air, N2, Ar, F5, and water OptiMix: O2, air, N2, Ar, F5, water, H2 |