Home
Install and Set Up the Plasma Power Supply
Power cord and plug requirements
Generator considerations
There are various considerations when you use a generator.
Adapter for 4-wire 1-phase connections (CSA 1-phase models only)
A 4-wire 1-phase connection (for example, NEMA 14-50R) is necessary for some generators.

Register your new Hypertherm system
Warranty information
Recycling information
Contact us
Safety information
Where to Find Information
Install and Set Up the Plasma Power Supply
- The Powermax45 SYNC system
  The Powermax45 SYNC® is a portable 45 A plasma cutting system that you can use for many handheld and mechanized cutting and gouging applications. The automatic gas and automatic voltage features make it easy to set up and use the system even if you have limited plasma cutting experience.
- Make sure that you have all the components
  It is important to make sure that you have all the components that come with your Powermax SYNC®.
- Hypertherm plasma power supply ratings
- Cutting specifications
- Correct position for the plasma power supply
  Make sure that the plasma power supply is in a safe position and location before you operate the cutting system.
- Connection requirements for electrical power
  Use the Hypertherm® input current ratings to determine conductor sizes for power connection and installation instructions.
- Power cord and plug requirements
  - Extension cord recommendations
    The recommended extension cord to use is different for different cord lengths and input voltages.
  - Generator considerations
    There are various considerations when you use a generator.
    - Adapter for 4-wire 1-phase connections (CSA 1-phase models only)
      A 4-wire 1-phase connection (for example, NEMA 14-50R) is necessary for some generators.
- Connect the gas supply
Operate the Plasma System
Cut and Mark with the Hand Torch
Gouge with the Hand Torch
Troubleshoot Common Problems
Complete Regular Maintenance Tasks

Adapter for 4-wire 1-phase connections (CSA 1-phase models only)

A 4-wire 1-phase connection (for example, NEMA 14-50R) is necessary for some generators.

If you must use a 4-wire 1-phase connection, use an adapter to connect the plasma power supply’s 3-wire power cord plug (NEMA 6-50P) to the 4-wire connector on the generator. Refer to Power cord and plug requirements for more information.