Put the TorchConnect console in position

There are three options to put the TorchConnect™ console in position. The factory-installed location for the mounting brackets is on the bottom panel of the console. But, you can move the brackets to the end or to the side.

  • Requirements to put system components in position
  • Worksite requirements for system components
  • A side position with the torch-lead connector on the bottom minimizes the risk that leaked water or coolant will accumulate in the console. Water or coolant in the console can damage internal electrical components.
  • A side position with the torch-lead connector on the top makes it necessary to install a support that holds the lead at a minimum bend radius of 15.25 cm (6 in.).
  1. Put the TorchConnect console in a position that obeys requirements for your cutting system configuration.

    If you have questions about what position to use or how to install the console, speak to your cutting machine supplier or regional Hypertherm® Technical Service team.

  2. Use the mounting brackets on the bottom, end, or side panel of the TorchConnect console to put the console in position, as shown.

    The following images show the three options to put the TorchConnect console in position:

    Figure 1. The three options to put the TorchConnect console in position
    The three options to put the TorchConnect console in position: bottom, end, and side.
    1 Bottom
    2 End
    3 Side
    Figure 2. Mounting-bracket locations and dimensions for the bottom-panel position
    Mounting-bracket locations and dimensions for the bottom-panel position
    Figure 3. Mounting-bracket locations and dimensions for the side-panel position
    Mounting-bracket locations and dimensions for a side-panel position