Before you install the hoses, cables, and leads, uncoil and examine them.
Use a hand-over-hand motion to uncoil the hoses, cables, and leads.
Keep the flat part of each hose, cable, or lead on the floor as you uncoil
it. Do not pull from one end to uncoil.
Notice
Pulling from one end to uncoil hoses, cables, and leads can cause
damage.
To avoid equipment damage, do not pull from one end to uncoil hoses, cables, and
leads.
Make sure that you have the correct hoses, cables, and leads.
New hoses, cables, and leads ship with a tag or label that has a part number
for identification. Do not order or use cables, hoses, or leads that are
incorrect or longer than necessary. If you coil a cable or lead because it
is too long, Electromagnetic Interference (EMI) problems can occur.
EMI problems can have a bad
effect on system performance.
Examine each hose, cable, and lead for damage.
Note:
Equipment damage can have a bad effect on system performance. Speak to your cutting machine supplier or
regional Hypertherm® Technical Service team.
