The plasma power supply weighs as much as
590 kg (1,300 lb), based
on voltage configuration. It must be lifted and moved with care to avoid injury or
damage.
HEAVY EQUIPMENT CAN CAUSE SERIOUS INJURY IF DROPPED – LIFT
CAREFULLY
When lifting or moving a heavy component:
Remove all cables, wires, and other potential obstacles that can get caught on the
component.
Only use lift equipment that can safely lift and support the component.
If you use the lift eye to lift the component, lift only that component. Do not
exceed the maximum lift-eye rating.
If you use a lift truck, use one with forks that extend along the entire bottom of
the component. The bottom of the component has lift-truck slots. Make sure to use
them.
Carefully put when you put the plasma power supply into position. Do not drop it
from any height.
Make sure that the equipment you use to lift and move heavy system components
has these features and capabilities:
Lift truck forks
Lift truck forks must be long enough to fully support and extend along the
entire bottom of the system component and rated to hold its weight.
Lifting equipment
Lifting equipment must be rated to hold the weight of the system component.
Use approved equipment with slow speeds to balance, lift, move, and put the
plasma power supply in a position that obeys requirements for your cutting
system configuration and plasma power supply type.
