Install the torch in the torch mounting bracket

Install the torch in the torch mounting bracket. Make sure it is level in all directions, then tighten the screws on the bracket.

  1. Remove the power from the cutting system:
    1. Set the line-disconnect switch to the OFF position.
    2. Make sure that the power-indicator Light Emitting Diode (LED) is not illuminated on the plasma power supply or other system components.
  2. Install the torch mounting bracket onto the torch lifter.

    Refer to the instruction manual for the torch lifter for information about how to install the torch mounting bracket in the torch lifter.

  3. Insert the torch, with the attached torch-lead assembly, into the torch mounting bracket, as shown.
    The image shows a torch in the mounting bracket.
    1 1.8 mm (3/16 inch)
    2 Lower torch sleeve
    3 Torch mounting bracket 5.72 cm (2.25 inches)
    4 Torch receptacle
  4. Move the torch assembly so that the torch mounting bracket is around the lower part of the torch sleeve and does not touch the torch receptacle.

    Make sure that the torch mounting bracket is as low as possible on the torch sleeve without touching the torch receptacle. This position can keep vibration at the torch tip to a minimum.

  5. Make sure that the torch is level (at a 0° angle) in all directions, as shown.

    You can use a digital level to measure alignment for standard-position cutting, marking, and piercing.

    This image shows the torch with a level below it.
    Note:

    During bevel cutting, the torch is at an angle (not perpendicular) to the workpiece. The torch position for XPR torches can be a range from 0° – 52°.

  6. Tighten the screws on the torch mounting bracket.