Install the work lead receptacle

  1. Set the new work lead receptacle into place in the front panel.

    Position the receptacle so the notch faces to the right (when you face the front of the power supply). Refer to Work lead receptacle components in the front panel.

    The image shows the notch orientation for the work lead receptacle.
  2. Install the nut and washer onto the back of the work lead receptacle.

    Use a 1/2 inch wrench. Tighten to 10.2 N∙m (90 lbf·in).

  3. Complete the following procedures:
    1. Attach the front panel.
    2. Install the component barrier.
    3. Install the plasma power supply cover and handle.
    4. Reconnect the power cord.
    5. Reconnect the gas supply.